INSTALLATION






(Refer to 9 - ENGINE/ENGINE BLOCK/CRANKSHAFT MAIN BEARINGS - STANDARD PROCEDURE)

NOTE: The main cap bolts should be examined before reuse. Bolt stretch can be checked by holding a scale or straight edge against the threads. If all the threads do not contact the scale the bolt must be replaced .




NOTE: Install new cross bolt and washer assembly upon reassembly.



(Refer to 9 - ENGINE/ENGINE BLOCK/CONNECTING ROD BEARINGS - STANDARD PROCEDURE)
(Refer to 9 - ENGINE/ENGINE BLOCK/CRANKSHAFT OIL SEAL - REAR - INSTALLATION)
(Refer to 9 - ENGINE/VALVE TIMING/TIMING CHAIN AND SPROCKETS - INSTALLATION)
(Refer to 9 - ENGINE/VALVE TIMING/TIMING CHAIN AND SPROCKETS - INSTALLATION)
(Refer to 9 - ENGINE/VALVE TIMING/TIMING CHAIN COVER - INSTALLATION)
(Refer to 9 - ENGINE/LUBRICATION/OIL PAN - INSTALLATION)
(Refer to 9 - ENGINE - INSTALLATION)