REMOVAL

NOTE: It is NOT necessary to discharge the A/C system to remove the engine.

NOTE: Do NOT remove the phenolic pulley from the P/S pump. It is not required for P/S pump removal.

• Intake air temperature (IAT) sensor
• Fuel Injectors
• Throttle Position (TPS) Switch
• Idle Air Control (IAC) Motor
• Engine Oil Pressure Switch
• Engine Coolant Temperature (ECT) Sensor
• Manifold Absolute Pressure MAP) Sensor
• Camshaft Position (CMP) Sensor
• Coil Over Plugs
• Crankshaft Position Sensor

NOTE: It is not necessary to release the quick connect fitting from the fuel supply line for engine removal.

NOTE: Recheck bolt torque for engine lift plate before removing engine.

NOTE: It is necessary to disconnect the front propshaft for access to the starter and left side exhaust flange.

NOTE: The exhaust clamps at the manifolds cannot be reused. New clamps must be used or leaks may occur.

NOTE: For manual transmission vehicles, the transmission must be removed from the vehicle, before the engine can be removed. The manual transmission will contact the floorpan before the engine clears the motor mounts, so it must be removed.

NOTE: It is not necessary to completely remove engine mount thru bolts, for engine removal.