DIAGNOSIS AND TESTING - POWER MIRRORS
WIRING VOLTAGE TEST
The following wiring test determines whether or not voltage is continuous through the body harness to switch.
(Refer to 8 - ELECTRICAL/POWER MIRRORS/POWER MIRROR SWITCH - REMOVAL)
If the test light illuminates, the wiring circuit between the battery and switch is OK.
If the lamp does not illuminate, first check fuse 25 in the Junction Block (JB). If fuse 25 is OK, then check for a broken wire.
Refer to the appropriate wiring information.
POWER MIRROR MOTOR TEST
If the power mirror switch is receiving proper current and ground and mirrors do not operate, proceed with power mirror motor test. Refer to the appropriate wiring information.
(Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - REMOVAL)
- Connect one to a 12 volt source
- Connect the other to a good body ground
- Refer to the Mirror Motor Test Chart for proper wire connections at the switch connector
| 12 VOLTS | GROUND | MIRROR
REACTION | ||
| SWITCH CONNECTOR | RIGHT | LEFT | ||
| PIN 2 | PIN 6 | - | UP | |
| PIN 6 | PIN 1 | - | LEFT | |
| PIN 6 | PIN 2 | - | DOWN | |
| PIN 1 | PIN 6 | - | RIGHT | |
| PIN 9 | PIN 6 | UP | - | |
| PIN 6 | PIN 10 | LEFT | - | |
| PIN 6 | PIN 9 | DOWN | - | |
| PIN 10 | PIN 6 | RIGHT | - | |