B2182- HEATED SEAT MODULE POWER SUPPLY HIGH
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
During heated seat operation.
- Set Condition:
This code is set immediately if the Heated Seat Module detects voltage over 16.0 volts on the (F937) Fused Ignition Switch Output (Run) circuit.
| Possible Causes |
| TROUBLE CODE PRESENT |
| CHARGING SYSTEM HIGH |
Diagnostic Test
1.CHECK PCM FOR CHARGING SYSTEM DTCAre there any Charging System DTC's set in the Powertrain Control Module?
Yes
- (Refer to 8 - ELECTRICAL/CHARGING - DIAGNOSIS AND TESTING) for Charging System diagnostic procedures.
- Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- The conditions that caused this code to set are not present at this time. Using Service Information, check the charging system.
- Perform BODY VERIFICATION TEST – VER 1. (Refer to BODY VERIFICATION TEST - VER 1).