B1BA7-OCCUPANT CLASSIFICATION SYSTEM VERIFICATION REQUIRED
- When Monitored:
With the CAN ignition status as IGN_RUN, the module tries to detect potentially damaging events and monitors the CAN Bus for the Impact messages (crash event causing one or more airbag or pretensioner to deploy) or upon detecting an Offset Event (if equipped).
- Set Condition:
This DTC will set if the module detects a potentially damaging event or the Impact messages from the CAN Bus input.
| Possible Causes |
| B1BA7-OCS VERIFICATION REQUIRED DTC ACTIVE |
Diagnostic Test
1.CHECK FOR OCCUPANT CLASSIFICATION MODULE (OCM) ACTIVE DTCs:- ACTIVE INTERNAL FAULTS
- IGNITION FAULTS
- BATTERY FAULT
- SEAT WEIGHT SENSOR DTCs
NOTE: Ensure the battery is fully charged.
Does the scan tool display any active DTCs listed above?
Yes
- Diagnose and repair the DTCs. Refer to the Table of Contents in this Section for a complete list of symptoms.
No
- Go To 2
2.VERIFY THAT DTC B1BA7-OCCUPANT CLASSIFICATION SYSTEM VERIFICATION REQUIRED IS ACTIVE
Does the scan tool display active: B1BA7-OCCUPANT CLASSIFICATION SYSTEM VERIFICATION REQUIRED?
Yes
- Go To 3
No
- Go To 5
3.PERFORM OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST
NOTE: Failure to follow the test instructions or aborting the test will cause faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: verify that all tests steps that led you here were performed as directed; verify that the ignition is in run; Wait 30 seconds after changing the seat weight before proceeding to allow the system to stabilize; only press scan tool buttons when directed to do so; and perform the Occupant Classification Module System Verification Test to completion.
Does the scan tool display active: B1BA7-OCCUPANT CLASSIFICATION SYSTEM VERIFICATION REQUIRED?
Yes
- Go To 4
No - But Other DTCs Present
- Diagnose and repair the DTCs. Refer to the Table of Contents in this Section for a complete list of symptoms.
No - No Active DTCs Present
- Perform *OCM SYSTEM VERIFICATION TEST.
4.PERFORM SENSOR TORQUE TEST
WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
NOTE: Failure to follow the test instructions or aborting the test will cause faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: verify that all tests steps that led you here were performed as directed; verify that the ignition is in run; Wait 30 seconds after changing the seat weight before proceeding to allow the system to stabilize; only press scan tool buttons when directed to do so; and perform the Occupant Classification Module System Verification Test to completion.
Does the scan tool display active: B1BA7–OCCUPANT CLASSIFICATION SYSTEM VERIFICATION REQUIRED?
Yes
- Perform the *Diagnosis/Checkout Procedure For Seat Weight Sensors.
- Perform *OCM SYSTEM VERIFICATION TEST .
No - But Other DTCs Present
- Diagnose and repair the DTCs. Refer to the Table of Contents in this Section for a complete list of symptoms.
No - Active DTCs Present
- Perform *OCM SYSTEM VERIFICATION TEST.
5.CHECK FOR ACTIVE DTC B1BA8-OCM SYSTEM OUT OF CALIBRATION/NOT CALIBRATED
Does the scan tool display active: B1BA8-OCM SYSTEM OUT OF CALIBRATION/NOT CALIBRATED?
Yes
- Diagnose and repair the DTC. Refer to the Table of Contents in this Section for a complete list of symptoms.
No
- Perform *OCM SYSTEM VERIFICATION TEST.