SUPPORT BRACKET

NOTE: The rear view mirror support bracket (or button) is permanently bonded to the inside of the windshield glass. If the bracket should become separated from the glass, it may be re-bonded using the following procedure. This procedure requires the use of a Rear View Mirror Adhesive kit that is available through Mopar® in single application packages that include a two-part adhesive and an accelerant with applicator.

• Crush the accelerant vial to saturate the felt applicator.
• Remove the paper sleeve.
• Apply accelerant to the bonding surface of the bracket.
• Allow the accelerant to dry for five minutes.
• Do not touch the bracket bonding surface after the accelerant has been applied.

• Apply one drop of adhesive at the center of the bracket contact area on the inside of the windshield glass.
• Apply an even coat of adhesive to the bonding surface of the bracket.
• Align the bracket with the marked position on the windshield glass.
• Press and hold the bracket in place for at least one minute.

NOTE: Verify that the mirror support bracket is correctly aligned, because the adhesive will cure rapidly.